Prizm L4-1800cc 1.8L DOHC (1993)
Park/Neutral Position (PNP) Switch Adjustment
b. Adjust PNP switch by aligning neutral basic line scribed in PNP switch with groove in PNP switch sleeve.
c. Tighten PNP switch to 48 in-lbs.
d. Tighten manual lever nut to 106 in-lbs.
e. Adjust shift select cable by rotating manual lever counterclockwise until it reaches Park position. Rotate manual lever clockwise two detent
positions until manual lever is in neutral position. Install shift select cable into manual lever and secure with cable nut Pull cable taut making
sure no deflection exists.
f.
Tighten shift select cable to 115 in-lbs.
g. Tighten left splash shield bolts to 44 in-lbs.
h. Tighten battery ground cable to 11 ft-lbs.
9. Ensure proper operation of PNP switch by performing the following steps:
a. Apply parking brake and block wheels.
b. With shifter in PARK, verify starter operation, then stop engine and turn key to the RUN position.
c. Move shifter to Neutral, turn start engine and verify starter operation.
d.
Verify that starter does not operate in Drive, 2nd, Low or Reverse.
