Storm L4-1600cc 1.6L DOHC (1991)
KICKDOWN SWITCH
Figure 3
Remove or Disconnect
1.
Kickdown switch electrical connectors.
^
Loosen kickdown switch locknuts.
2.
Kickdown switch from accelerator pedal bracket by rotating the switch counterclockwise.
Install or Connect
1.
Kickdown switch to accelerator pedal bracket by rotating switch clockwise until a click is heard. Rotate the switch an additional one-half turn
clockwise after the click is heard.
^
Tighten the kickdown switch locknuts.
2.
Kickdown switch electrical connectors.
Kickdown Solenoid
Figure 4
Remove or Disconnect
1.
Kickdown solenoid electrical connector (under RH side of battery tray).
^
Raise and suitably support vehicle. Refer to Section 0A in the 1990 or 1991 GEO Storm Service Manual.
2.
Kickdown solenoid from transaxle by rotating counterclockwise.
3.
Kickdown solenoid O-ring.
Install or Connect
1.
New kickdown solenoid O-ring.
2.
Kickdown solenoid to transaxle by rotating clockwise.
^
Lower vehicle.
3.
Kickdown solenoid electrical connector (under RH side of battery tray).