Storm L4-1600cc 1.6L SOHC (1990)
Standby Power Supply: Service and Repair
Do not open the DERM case for any reason. Touching the connector pins or soldered components may cause electrostatic discharge damage.
Repair of a faulty DERM is by replacement only.
Fig. 323 DERM Replacement
1.
Deactivate airbag system as described under MAINTENANCE PROCEDURES/AIRBAG DEACTIVATION.
2.
Remove front bezel and console side panels.
3.
Disconnect DERM electrical connector.
4.
Remove two DERM retaining bolts, then the DERM, Fig. 323.
5.
Reverse procedure to install, noting the following:
a. Torque DERM retaining bolts to 62 inch lbs.
b. Following installation, activate airbag system as described under MAINTENANCE PROCEDURES/AIRBAG ACTIVATION.
c. Turn ignition switch to the On position and verify the ``Inflatable Restraint'' indicator flashes 7 to 9 times then turns Off. If indicator does not
respond, refer to DIAGNOSIS AND TESTING PROCEDURE/TESTING PROCEDURES/RETRIEVING TROUBLE CODES.
