Storm L4-1600cc 1.6L SOHC (1990)
Steering Gear: Service and Repair
Removal/Installation
1.
Remove intermediate steering shaft cover, then remove dust boot ring attaching nuts.
2.
Raise and support vehicle, then remove wheel and tire assembly.
3.
Remove dust boot from bulkhead, then position drain pan under vehicle.
4.
Remove intermediate steering shaft pinch bolt.
5.
Using Tie Rod End Remover tool No. J 21687-02 or equivalent, disconnect tie rod ends at steering knuckles.
6.
Remove power steering fluid line hold-down bracket.
7.
Disconnect power steering high pressure line, drain power steering fluid, then remove rack to crossmember attaching bolts.
8.
Remove steering gear bracket attaching nut and bolt, then position steering gear from mounts.
9.
Disconnect power steering return line, then disconnect intermediate shaft knuckle.
10.
Remove steering gear through right side of vehicle.
11.
Reverse procedure to install.
