Storm L4-1800cc 1.8L DOHC (1993)
Figure 23
2. If terminal is to be re-used, re-form locking tang.
3. Make repair.
a. Pull terminal wire out of connector body.
b. Cut wire as close to terminal as possible.
c. Strip 5 mm (3/16") of insulation from the wire (see Figure 23).
d. Crimp new terminal to wire.
e. Solder with rosin core solder.
f.
Carefully pull on wire to draw terminal into connector body until it locks.
Push-to-Seat Connectors
Figure 1 - Typical Push-To-Seat Connector
NOTE: The following general repair procedures can be used to repair most types of connectors. Use the Pick(s) or Tools that apply to your
terminal. Use Terminal repair kit J 38125 or equivalent. The steps are illustrated with typical connectors. Your connector may be different, but the
repair steps are similar. Some connectors DO NOT require all the steps shown. Skip the steps that DO NOT apply.
Figure 2
