geo Workshop Repair Guides

Geo Workshop Service and Repair Manuals

Part 1 of 3|Page 2710 > < Part 1 of 3
Page 2
background image

Fuel Flow Diagram

CIRCUIT DESCRIPTION:

The fuel pump delivers fuel to the fuel rail and injectors, where the system pressure is controlled from 284 to 325 kPa (41 to 47 psi) by the pressure
regulator. Excess fuel is returned to the fuel tank. When the engine is stopped, the pump can be energized by applying battery voltage to the test terminal
located in the engine compartment.

TEST DESCRIPTION:  Numbers below refer to circled numbers on the diagnostic chart.

1.

Use pressure gauge J 34730-1 and adapter J 35957-10. Wrap a shop towel around the fuel pressure tap to absorb any small amount of fuel leakage
that may occur when installing the gauge. (The pressure will not leak down after the fuel pump is stopped on a correctly functioning system).

2.

While the engine is idling, manifold pressure (vacuum) is low. When applied to the fuel regulator diaphragm, the pressure will result in a lower 
fuel pressure of about 190-200 kPa (25-30 psi).

3.

The application of vacuum to the pressure regulator should result in a fuel pressure drop.

4.

Pressure leak-down may be caused by one of the following:

^

In-tank fuel pump check valve not holding.

^

Pump coupling hose leaking.

^

Fuel pressure regulator valve leaking.

^

Injector sticking open/leaking.

DIAGNOSTIC AIDS:

Improper fuel system pressure may contribute to one or all of the following symptoms:

-

Cranks but won't run.

-

Cutting out (May feel like ignition problem).

-

Hesitation, loss of power or poor fuel economy, See: Computers and Control Systems/Testing and Inspection

The follow procedure outlines the installation and removal of the Fuel Pressure Gauge Assembly. Make certain to observe all "Cautions" while
performing this procedure.

REQUIRED TOOLS:

Port Fuel Pressure Gauge .......................................................................................................................................................................................  J 34730-1
Fuel Rail Adaptor ......................................................................................................................................................................................................  J 38347

Part 1 of 3|Page 2710 > < Part 1 of 3