Tracker 4x2 L4-1.6L SOHC TBI (1994)
Malfunction Indicator Lamp: Service and Repair
Federal Emissions
Federal Models
The Check Engine lamp will be illuminated when the ignition switch is in the On position with engine not operating. When engine is started, the
Check Engine lamp should go off. If lamp remains on, either a service interval is indicated or a code has been stored by the Electronic Control Module
(ECM) memory.
Instrument Panel Wiring
At mileage intervals of 50,000, 80,000 and 100,000 miles, the Check Engine lamp will be illuminated indicating required service and maintenance is
to be performed. After performing the required service, the lamp may be reset by moving the slider switch located behind the instrument cluster, attached
to the I/P next to the left speaker.
If a service code has been stored in the ECM memory, perform diagnosis and repair, then place ignition switch in Off position and clear codes stored
in the ECM memory by disconnecting the battery ground cable for approximately 20 seconds.
1.
The MIL cancel switch is located behind the instrument panel, attached to the instrument panel next to left speaker.
2.
To reset the switch, move the switch to "OFF."
NOTE: Disconnecting the battery or fuses will NOT reset this light if it is on due to maintenance.
^
If battery ground cable is disconnected, theft deterrent features may be activated. You may need vehicle security codes to enable radio operation.
Components such as clocks, electronically tuned radios etc., will have to be reset.
