Tracker 4x2 L4-1.6L SOHC TBI (1994)
Coolant Temperature Sensor/Switch (For Computer): Service and Repair
REMOVAL:
1.
Disconnect negative battery cable, and drain cooling system.
2.
Disconnect connector from Engine Coolant Temperature Sensor (ECT).
3.
Remove ECT Sensor from manifold.
INSTALLATION:
1.
Clean mating surfaces of intake manifold and ECT Sensor.
2.
Use a new gasket.
3.
Install ECT Sensor in intake manifold.
4.
Tighten to 45 Nm (33 lb-ft).
5.
Connect the connector securely.
6.
Refill cooling system.
7.
Connect negative battery cable.
