Tracker 4x2 L4-1.6L VIN 6 (1995)
2. Two coolant hoses to throttle body.
3. EGR SV valve vacuum hose to throttle body.
4. Accelerator cable bracket to throttle body; secure with one nut, one bolt and one screw. Tighten throttle body nut and bolt to 18-28 Nm (13.5-20
lb. ft).
5. TP sensor electrical connector.
6. Air intake pipe to throttle body; secure with one clamp and three bolts. Tighten three air intake pipe bolts to 15 Nm (11 lb. ft.).
7. Two coolant hoses, PCV valve hose and IAC valve air intake hose to air intake pipe.
8. Air intake hose to air intake pipe; secure with one clamp.
9. Accelerator cable and throttle cable (automatic transmission) to throttle lever.
10. Throttle cover; secure with three bolts. Tighten Throttle cover bolts to 15 Nm (11 lb. ft.).
11. Negative (-) battery cable. Tighten negative (-) battery cable-to-negative (-) battery terminal retainer to 15 Nm (11 lb. ft.).
ADJUST
1. Accelerator cable. Refer to Throttle Cable/Linkage.
2. Throttle valve cable. Refer to Transmission and Drivetrain / Automatic Transmission/ Transaxle / Throttle Valve Cable.
3. TP sensor. Refer to Computers and Control Systems / Throttle Position Sensor.
COOLING SYSTEM
Refill engine coolant to proper level. Refer to Cooling System / Service and Repair.
AFTER REPAIR INSPECTION
Turn ignition switch to "ON,' and then back to "LOCK" to pressurize the fuel system. Check for any fuel leaks.
