geo Workshop Repair Guides

Geo Workshop Service and Repair Manuals

Throttle Position Sensor > < Power Steering Pressure Switch|Locations|Page 1764
Page 2
background image

wheel increases power steering oil pressure and its load on an idling engine. The pressure switch will close before the load can cause an idle problem.
Closing the switch causes ECM terminal "Y13" to read less than 1 volt. The ECM will increase the idle air rate and prevent engine load stall.

TEST DESCRIPTION:  Numbers below refer to the circled numbers on the diagnostic chart.

1.

Checks for ECM signal voltage at "Y13" and confirm good ground at PSPS housing.

2.

Maximum resistance, or infinity, indicates an open switch.

3.

Less than 1 ohm indicates that the switch is closed when the power steering pressure is high. Switch is OK.

DIAGNOSTIC AIDS:

A pressure switch that will not close, or an open at "Y13" or loss of ground at PSPS, may cause the engine to stop when power steering loads are high. A
switch that will not open or "Y13" shorted to ground or open, may affect idle quality.

Throttle Position Sensor > < Power Steering Pressure Switch|Locations|Page 1764