Tracker 4x4 L4-1.6L VIN 6 (1995)
Removing Snap Ring
4. Snap ring and shim, using appropriate snap ring pliers.
5. A/C compressor clutch pulley from compressor. Tap off with plastic hammer if necessary.
NOTICE: Be careful not to damage pulley when tapping it off. Use a pulley puller, like a J 8433, to assist in the removal of the clutch pulley.
Install or Connect
1. A/C compressor clutch pulley to compressor; secure with snap ring and shim.
2. Pressure plate to compressor drive shaft.
Measure
Measureing Pressure Plate Clearance
^
Clearance between clutch pulley and pressure plate.
-
Clearance should be 0.35 to 0.65 mm (0.014 to 0.025-inch).
3. Pressure plate washer and nut to compressor drive shaft by using tool J 41384.
Tighten
^
Pressure plate nut to 15-20 N.m (10.8-15.2 lb.ft.).
