Tracker 4x4 L4-1.6L VIN 6 (1995)
7. Wheel bearing oil seal, then the bearing circlip.
8. Bearing outer race using J-37772 with J-8092 and a hammer.
INSTALL OR CONNECT
1. Using J-8092 and J-37777, press fit bearing outer race until firmly seated in wheel hub.
2. Pack bearing with GM Bearing Lubricant P/N 1051344 or equivalent.
3. Bearing circlip, then the bearing oil seal using J-37774.
4. Fill oil seal recess and cover oil seal lip with P/N 1051344.
5. Wheel hub assembly onto spindle, then the spindle thrust washer.
6. Using J-37763 install wheel bearing nut and tighten to 210 Nm (155 ft lbs).
7. Brake disc and caliper assembly. Torque caliper bolts to 88 Nm (65 ft lbs).
8. Locking hub assembly and wheel.
Please Read
The four wheel drive version of this vehicle has non-serviceable sealed cartridge bearings both front and rear. The two wheel drive version has sealed
bearings in the rear and serviceable, non-sealed bearings in the front. If any fault is found with a sealed bearing, it must be replaced.
