Tracker 4x4 L4-1.6L VIN 6 (1995)
Fuel Pressure Pulsation Damper: Service and Repair
Fuel Pulsation Damper
FUEL PULSATION DAMPER REPLACEMENT
REMOVE OR DISCONNECT
1. Relieve fuel system pressure. Refer to Fuel Pressure Relief Procedure under Service and Repair.
2. Negative (-) battery cable.
3. Damper from fuel rail. Use a shop towel to catch any remaining fuel.
INSTALL OR CONNECT
^
Apply a thin coat of oil to the new gasket.
1. Fuel pulsation damper and new gasket to fuel rail. Tighten fuel pulsation damper to 25-35 Nm (18.5-25 lb. ft.) using a backup wrench.
2. Negative battery cable. Tighten negative battery cable-to-negative (-) battery terminal retainer to 15 Nm (11 lb. ft.).
AFTER REPAIRS INSPECTION
Turn ignition switch to "ON" and then back to "LOCK" to pressurize the fuel system. Check for any fuel leaks.