Tracker 4x4 L4-1.6L VIN 6 (1995)
^
Engine not running, ignition switch in the "ON" position - 250-300 kPa (36-43 psi).
^
Within one minute with engine not running, ignition switch in the "ON" position - pressure should hold at about 180 kPa (26 psi).
If pressure is not within specification, refer to On-Board Diagnostic System Check under Computers and Control Systems.
8. Relieve fuel system pressure. Refer to Fuel Pressure Relief Procedure.
9. Disconnect J34730-1 and J41041 from fuel rail. Use shop towel to catch any remaining fuel that may leak.
10. Install fuel rail plug bolt. Tighten fuel rail plug bolt to 45-55 Nm (33-39.5 lb. ft.).
11. Connect negative (-) battery cable. Tighten negative (-) battery cable-to-negative (-) battery terminal retainer to 15 Nm (11 lb. ft.).
12. Turn ignition switch to "ON," and then back to "LOCK" to pressurize the fuel system. Check for any fuel leaks.
