Tracker 4x4 L4-1.6L VIN 6 (1995)
NOTE: The following general repair procedures can be used to repair most types of connectors. Use the Pick(s) or Tools that apply to your terminal.
Use Terminal repair kit J 38125 or equivalent. The steps are illustrated with typical connectors. Your connector may be different, but the repair steps are
similar. Some connectors DO NOT require all the steps shown. Skip the steps that DO NOT apply.
Figure 21
Figure 22
1. Separate connector halves. Using the proper pick or removal tool, remove terminal (see Figures 21 & 22).
a. Pull lead gently.
b. Insert pick from front of connector into canal.
c. Pry tab up with tool.
d. Push lead to remove.
Figure 23
2. If terminal is to be re-used, re-form locking tang.
3. Make repair.
a. Pull terminal wire out of connector body.
b. Cut wire as close to terminal as possible.
c. Strip 5 mm (3/16") of insulation from the wire (see Figure 23).
d. Crimp new terminal to wire.
e. Solder with rosin core solder.
f.
Carefully pull on wire to draw terminal into connector body until it locks.
Push-to-Seat Connectors
