geo Workshop Repair Guides

Geo Workshop Service and Repair Manuals

Campaign - Rear Axle Housing Fracture|Page 3079 > < Campaign - Rear Axle Housing Fracture
Page 2
background image

Dealer Campaign Responsibility and Parts Information

All unsold new vehicles in dealers' possession and subject to this campaign must be held and inspected/repaired per the service procedure of this
campaign bulletin before owners take possession of these vehicles.

Dealers are to service all vehicles subject to this campaign at no charge to owners, regardless of mileage, age of vehicle, or ownership, from this time
forward.
 
Owners of vehicles recently sold from your new vehicle inventory with no owner information indicated on the dealer listing, are to be contacted by the
dealer, and arrangements made to make the required correction according to the instructions contained in this bulletin. This could be done by mailing to
such owners a copy of the owners letter accompanying this bulletin. Campaign follow-up cards should not be used for this purpose, since the owner may
not as yet have received the notification letter.

In summary, whenever a vehicle subject to this campaign enters your vehicle inventory, or is in your dealership for service in the future, please take the
steps necessary to be sure the campaign correction has been made before selling or releasing the vehicle.

OWNER NOTIFICATION

Owners will be notified of this campaign on their vehicles by Chevrolet Motor Division (see copy of owner letter included with this bulletin). Owners of
vehicles which have already been repaired under the initial recall must be recontacted and arrangements must be made to reinspect the
replacement axle at the owner's home or location of choice.

SPECIAL INSPECTION GAUGE

Each Dealer was shipped an inspection gauge for use in this campaign. Tools were sent to dealers at no charge during the week of April 18, 1994.

PARTS INFORMATION

While the rear axle shaft housing tube is the cause of this condition, dealers are to replace the complete rear axle assembly.

Parts required to complete this campaign are to be obtained from General Motors Service Parts Operations (GMSPO). To ensure these parts will be
obtained as soon as possible, they should be ordered from GMSPO as a SPAC CASE (vehicle VIN will be required) and GMSPO will arrange for an
exchange axle assembly to be shipped NEXT DAY AIR directly to your dealership. THE EXCHANGE AXLE WILL BE SHIPPED PREPAID.

NOTICE:
REAR AXLE ASSEMBLY PART NUMBERS 91171637, 91171638 AND 91171639 WILL NOT BE RETURNABLE TO GMSPO UNDER THE
RETURN PARTS PROGRAM.

Service Procedure

REINSPECTION OF PREVIOUSLY REPAIRED VEHICLES

Vehicles which had axles replaced prior to the issuing of this supplement are to be reinspected using the service procedure in the initial bulletin and also
following the revisions. Some axles which may have been used when 94C31 was originally issued may have the same suspect welds as the axles which
were replaced. Vehicles which were inspected and did not have the axle replaced do not need to be reinspected.

AXLE INSPECTION PROCEDURE

1.

Raise vehicle on hoist.

Campaign - Rear Axle Housing Fracture|Page 3079 > < Campaign - Rear Axle Housing Fracture