Acadia FWD V6-3.6L (2007)
1. Remove the outboard front seat adjuster bolt finish cover. Use a small flat-bladed tool to release the tab in the rear of the cover (1).
2. Remove the inboard front seat adjuster bolt finish cover. Pull upward to release the retainer clip securing the cover to the seat adjuster (2).
3. Remove the two front seat mounting bolts (3).
4. Install two M12 flat washers (one per mounting bolt, two per seat), such as *Kent Industries Part #P96851M01 or the equivalent, between the seat
adjuster assembly and the vehicle floor where the seat bolt fastens to the floor. Ensure that the washer is centered over the hole in the sheet metal
(Washer Dimension, O.D.24 mm, I.D.13 mm Thickness 2.5 mm).
5. Reinstall the two front seat mounting bolts (3).
Tighten
Tighten the bolts to 45 Nm (33 lb ft).
6. Lubricate the seat tracks with an aerosol lubricant such as GM Super Lube, P/N 12346241 (in Canada, 10953474), or the equivalent.
7. Reinstall the front seat adjuster bolt finish covers.
Cycle the seat to verify that the seat doesn't bind or stick. If the seat is still binding, proceed to the following additional steps.
Note
The following steps (1-7) only apply to vehicles built before January 25, 2011. Vehicles built after this date use revised seat tracks.
