Acadia FWD V6-3.6L (2007)
4. Connect the brake pedal pushrod to the brake pedal and install the clevis pin (2).
5. Install the brake pedal pushrod retaining clip (1).
6. Install the knee bolster.
7. Install the left side instrument panel insulator panel.
Important: Ensure the master cylinder to vacuum brake booster seal is properly installed on the back of the master cylinder housing
against the face of the master cylinder flange. Inspect the seal for damage and replace, if necessary.
8. Position the master cylinder to the vacuum booster.
9. Install the 2 brake master cylinder nuts.
Tighten the nuts to 20 N.m (15 lb ft).
