Acadia FWD V6-3.6L (2007)
10. Position the BPMV assembly over the studs.
11. Install the 2 nuts (2) to the brake pressure modulator valve (BPMV) and bracket assembly.
Tighten the nuts to 20 N.m (15 lb ft).
12. Install the front and rear brake pipes (1) to the routing clip on the frame rail.
13. Connect the master cylinder fluid level sensor electrical connector (1).
14. Connect the vacuum brake booster vacuum sensor electrical connector (3).
Important: If necessary, a small amount of denatured alcohol may be used to aid installation of the brake booster check valve hose. Do
not use soap.
15. Install the vacuum brake booster check valve hose to the vacuum brake booster check valve (2).
16. Install the air cleaner assembly.
