Acadia FWD V6-3.6L (2007)
7. Release the wheel speed sensor wire harness routing clips (4) and (5) from the suspension strut.
Important: Clean the wheel speed sensor mounting area on the steering knuckle of any accumulated dirt and debris.
8. Remove the wheel speed sensor bolt.
9. Pull the wheel speed sensor straight up and out of the steering knuckle.
Installation Procedure
1. Install the wheel speed sensor to the steering knuckle.
Notice: Refer to Fastener Notice.
2. Install the wheel speed sensor bolt.
Tighten the bolt to 9 N.m (80 lb in).
