Acadia FWD V6-3.6L (2007)
-
The ECM detects the analog cruise control switch input is out of the normal voltage range.
TAC Inhibit
-
The ECM detects a fault within the throttle actuator control (TAC) system.
TCS
-
The ECM detects that the traction control system had been activated. It is also possible that a tire with low air pressure can also set this
disengagement reason.
Trans. DTC
-
The ECM detects a transmission gear fault.
Under Set Speed
-
The ECM detects that the vehicle speed is less than the cruise memory speed by more than a calibrated amount.
VSES
-
The ECM detects that the vehicle stability enhancement system had been activated.
Scan Tool Data Definitions (Cruise Control)
Scan Tool Data Definitions (Cruise Control)
The Scan Tool Data Definitions contains a brief description of all cruise control related parameters available on the scan tool.
BPP Circuit Signal
-
The scan tool displays Applied or Released. The electronic brake control module (EBCM) monitors the brake pedal position (BPP) circuit signal.
The engine control module (ECM) receives a GMLAN serial data message from the EBCM indicating the status of the BPP circuit signal.
BPP Signal
-
The scan tool displays Applied, Released or Invalid. The electronic brake control module (EBCM) monitors the status of the brake pedal position
(BPP) sensor. The ECM receives a GMLAN serial data message from the EBCM indicating the status of the BPP signal.
Cruise Control Active
-
The scan tool displays Yes or No. The ECM determines the current status of cruise control operation. An active cruise control system is displayed
as Yes.
Cruise Control Switch
-
The scan tool displays On, Off, Set, Resume or Error. The BCM monitors the signal circuit of the cruise control switch.
Cruise Disengage (1 - 8) History
-
The scan tool displays the last 8 reasons why the cruise control system was disengaged. Refer to the Scan Tool Data Definitions (Disengaged
History) for descriptions.
Cruise Inhibited
-
The scan tool displays Yes or No. The ECM determines when the conditions for inhibiting the cruise control system exists. An inhibited cruise
control system is displayed as Yes.
Cruise Inhibit Reason
-
The scan tool displays the reason that the cruise control is inhibited as detected by the ECM.
Cruise On/Off Switch
-
The scan tool displays On or Off. The ECM monitors the signal circuit of the cruise control switch. A closed switch is displayed as On.
Cruise Resume/Accel. Switch
-
The scan tool displays On or Off. The ECM the monitors the cruise control switch signal circuit. A closed switch is displayed as On. The cruise
control On/Off switch must be switched On in order to correctly view the Cruise Resume/Accel. Switch parameter. The BCM sends a GMLAN
message to the ECM indicating the status of the resume/accel switch.
Cruise Resume/Accel. Switch
-
The scan tool displays Active, Inactive or Invalid. The BCM the monitors the cruise control switch signal circuit. A closed switch is displayed as
On. The cruise control On/Off switch must be switched On in order to correctly view the Cruise Resume/Accel. Switch parameter. The BCM
sends a GMLAN message to the ECM indicating the status of the cruise resume/accel switch.
Cruise Set/Coast Switch
-
The scan tool displays On or Off. The BCM the monitors the cruise control switch signal circuit. A closed switch is displayed as On. The cruise
