Acadia FWD V6-3.6L (2007)
2.
Complete odometer worksheet and have it ready when calling the Customer Support Center (TCSC). Refer to the work sheet shown.
3.
Using VCI number provided by TCSC, program instrument panel clusters (IPC).
4.
Key ON and verify correct odometer value.
5.
Key OFF.
6.
Remove 10 amp Display fuse (1), wait at least 5 seconds, then re-install 10 amp display fuse.
6.1.
Display fuse is located at I/P fuse block under the right side of instrument panel.
6.2.
Remove instrument panel insulator/closeout panel push-pins.
6.3.
Remove instrument panel insulator/closeout panel.
6.4.
Install instrument panel insulator/closeout panel.
6.5.
Install instrument panel insulator/closeout panel push-pins.
7.
Key ON and verify correct odometer value.
8.
Use Tech 2(R) to check for any IPC diagnostic trouble codes (DTC'S). If any DTCs are present, refer to Service Information (SI) for proper
diagnostic procedures.
Clear any DTCs that may have set in the ECM and TCM after reprogramming both modules.
Courtesy Transportation
The General Motors Courtesy Transportation program is intended to minimize customer inconvenience when a vehicle requires a repair that is covered
by the New Vehicle Limited Warranty. The availability of courtesy transportation to customers whose vehicles are within the warranty coverage period
and involved in a product program is very important in maintaining customer satisfaction. Dealers are to ensure that these customers understand that
