Acadia FWD V6-3.6L (2007)
voltage guidelines are not observed.*
The ignition switch must be in the proper position. The Tech 2(R) prompts you to turn ON the ignition, with the engine OFF. DO NOT change the
position of the ignition switch during the programming procedure, unless instructed to do so.
Make certain all tool connections are secure, including the following components and circuits:
The RS-232 communication cable port
The connection at the data link connector (DLC)
The voltage supply circuits.
*DO NOT* disturb the tool harnesses while programming. If an interruption occurs during the programming procedure, programming failure or control
module damage may occur.
*DO NOT* turn OFF the ignition if the programming procedure is interrupted or unsuccessful. Ensure that all control module and DLC connections are
secure and the TIS terminal operating software is up to date.
*You may see a message on TIS 2 Web that instructs you to replace the SDM if the current calibration number for the system part is any of the
following: 15925927, 15925928, or 15925929. Disregard this message; the vehicles involved in this recall do not have these calibration numbers.
Proceed with programming.*
Verify that there is a battery charge of 12 to 16 volts. The battery must be able to maintain a charge during programming. Use an additional jump battery
if necessary.
Connect the Tech 2 to the vehicle and TIS 2 Web.
Turn the ignition to the ON position with the engine OFF.
After all warning chimes inside the vehicle have stopped, turn on the Tech2.
On TIS 2 Web, go into SPS Programming.
Select Pass Thru programming.
Follow instructions on the TIS 2 Web. When you get to the Supported Controllers screen.
Scroll down in the top box and select SDM (Sensing and Diagnostic Module).
In the lower box, select Normal.
Select Next.
Select NEXT when the calibrations screen displays.
Follow on-screen prompts until programming is completed.
When programming is complete.
Turn off Tech 2.
Turn the ignition switch to the OFF position.
*After programming the SDM, you must complete steps: 11-22.*
Wait 60 seconds.
Turn the ignition switch to the ON position.
Turn the Tech 2(R) ON.
Using the Tech 2(R), perform the Setup SDM Primary Key in SIR Module Setup.
*The airbag telltale on the instrument panel must be flashing in order to perform Step 15.*
