Acadia FWD V6-3.6L (2007)
8. Tighten the rear front frame mounting bolts (1).
Tighten the bolts to 100 N.m (74 lb ft) plus 90 degrees
9. Tighten the front frame reinforcement mounting bolts (1). Left side shown, right side similar.
Tighten the bolts to 50 N.m (37 lb ft)
10. Tighten the front frame mounting bolts (2). Left side shown, right side similar.
Tighten the bolts to 100 N.m (74 lb ft) plus 90 degrees
11. Clean any excess fluid from the vehicle and remove the drain pans.
12. Install the steering gear heat shields.
13. Install the right side catalytic convertor.
14. Install the frame brace.
15. Install the underbody rear side rails.
