Acadia FWD V6-3.6L (2007)
1. Install the small seal clamp (1) to the seal. Do not crimp the clamp.
2. Slide the inner seal onto the wheel drive shaft bar and locate the lip of the seal groove on the wheel drive shaft bar.
Important: Ensure the seal clamp is positioned correctly in the seal groove.
3. Using the J 35910, crimp the small seal clamp.
4. Measure the clamp gap width.
Clamp gap width should not exceed 2.15 mm (0.85 in).
5. Install the tripot spider assembly to the wheel drive shaft bar, until seated against shoulder.
6. Install the retaining ring in the groove of the wheel drive shaft bar with suitable pliers.
7. Place approximately half of the grease in the kit to the seal and place the remainder in the tripot housing.
