C 1500 Truck 2WD V6-262 4.3L VIN Z (1992)
9.
Mark the center nose portion of the lower control arm. Place another mark 2 inches on either side of center (Figure No. 1).
10.
Using a die grinder or equivalent, take care not to remove more than 2 mm (.08 inches) of metal from the control arm nose to obtain clearance
between the control arm and brake rotor.
11.
Inspect the outer nose of the control arm for the flange thickness. The thickness should be 10 mm - 14 mm (.39 -.55 inches). (Figure No. 2).
12.
If the flange thickness is greater than 14 mm (.55 inches), use a die grinder or equivalent to remove excessive metal from the bottom to obtain the
proper thickness.
13.
Clean the unfinished metal, then paint black.
