C 1500 Truck 2WD V6-262 4.3L VIN Z (1992)
Hydraulic Control Assembly - Antilock Brakes: Service and Repair
Electronic Brake Control Module And Antilock Pressure Valve
NOTE: The Antilock Pressure Valve (APV) valve is not serviceable. It should be replaced when the diagnostic trouble code charts show it is the cause
of a malfunction.
REMOVAL
CAUTION: Do not touch the electrical connections and pins or allow them to come into contact with brake fluid as this will damage the Electronic
Brake Control Module (EBCM).
1. Remove brake pipe fittings.
CAUTION: Do not allow the Antilock Pressure Valve to hang by the wiring harness.
2. Remove bolts.
3. Remove bottom electrical connector from EBCM.
4. Remove Antilock Pressure Valve.
INSTALLATION
1. Install Antilock Pressure Valve.
-
Tighten bolts to 29 Nm (21 ft lbs).
2. Install electrical connector to the module.
-
If there is brake fluid on the connectors, clean them with water followed by denatured alcohol.
3. Install brake pipes.
-
Tighten fittings to 24 Nm (18 ft lbs).
4. Bleed the system. See: Brake Bleeding/Service and Repair/Hydraulic System Bleeding/With ABS System
