gmc Workshop Repair Guides

GMC Workshop Service and Repair Manuals

With 4L60 Automatic Transmission or Manual Transmission|Page 3059 > < With 4L60 Automatic Transmission or Manual Transmission|Page 3057
Page 2
background image

Electronic Spark Control (ESC) Circuit

Circuit Description:

Electronic Spark Control (ESC) is accomplished with a module that sends a voltage signal to the ECM. As the knock sensor detects engine knock,
the voltage from the ESC module to the ECM is shut "OFF" and this signals the ECM to retard timing, when the engine rpm is over about 900.

Test Description:

Numbers below refer to circled numbers on the diagnostic chart.

1. If a code 43 is not set, but a knock signal is indicated while operating at 1500 rpm, listen for an internal engine noise. Under a no load

condition there should not be any detonation, if knock is indicated, an internal engine problem may exist.

2. Usually a knock signal can be generated by tapping on the right exhaust manifold. This test can also be performed at idle. Test Number 1 was

run at 1500 rpm to determine if a constant knock signal was present, affecting engine performance.

3. This tests whether the knock signal is due to the sensor, a basic engine problem, or the ESC module.

4. If the module ground circuit is faulty, the ESC module will not function correctly. The test light should light indicating the ground circuit is

OK.

5. Contacting CKT 496, with a test light to 12 volts, should generate a knock signal to determine whether the knock sensor is faulty, or the ESC

module can't recognize a knock signal.

Diagnostic Aids:

"Scan" tools may be used to diagnose the ESC system. The knock signal can be monitored to see if the knock sensor is detecting a knock condition
and if the ESC module is functioning, knock signal should display "yes", whenever detonation is present. For 2.5L engines, the knock retard
position on the "Scan" displays the amount of spark retard the ECM is commanding. The ECM can retard the timing up to 20 degrees.

If the ESC system checks OK, but detonation is the complaint, refer to Detonation/Spark Knock/PingsSee: Computers and Control
Systems/Testing and Inspection/Symptom Related Diagnostic Procedures/Detonation/ Spark Knock

With 4L60 Automatic Transmission or Manual Transmission|Page 3059 > < With 4L60 Automatic Transmission or Manual Transmission|Page 3057