C 1500 Truck 2WD V6-262 4.3L VIN Z (1992)
Fig. 3 Axle, Hub & Drum Components.
Remove or Disconnect
1. Bolts (55).
-
Rap the axle shaft (53) flange lightly with a soft faced hammer to loosen the shaft.
-
Grip the rib on the axle shaft (53) flange with a locking plier and twist, to start shaft removal.
2. Axle shaft (52) from the tube.
Clean
-
Axle shaft (53) flange. Remove old RTV or gasket (51).
-
Outside face of the hub assembly.
Inspect
-
All parts and replace as necessary.
Install or Connect
1. Axle shaft (53) with a gasket or RTV applied.
-
Be sure the shaft splines mesh into the differential side gear.
-
Align the axle shaft holes with the hub holes.
2. Bolts (55). Tighten bolts (55) to 156 Nm (115 ft. lbs.).
Wheel Bearing
REAR WHEEL BEARING
1.
Raise and support vehicle.
2.
Remove axle shaft.
3.
Remove hub and drum.
4.
Remove oil seal, inner bearing and retaining ring.
5.
Remove outer bearing.
6.
Reverse procedure to install.
Axle Shaft, Replace
REAR AXLE SHAFT