C 1500 Truck 2WD V6-4.3L VIN W (2001)
Oil Pressure Sensor: Service and Repair
TOOLS REQUIRED
J 41712 Oil Pressure Switch Socket
REMOVAL PROCEDURE
IMPORTANT: Clean the area around the sensor and Distributor before removal. Do not allow debris to enter the engine.
1. Remove the distributor. Refer to Distributor Replacement in Igniton System.
2. Disconnect the engine oil pressure sensor electrical connector.
3. Remove the engine oil pressure sensor using the J 41712.
IMPORTANT: Note the alignment of the engine oil pressure sensor fitting prior to removal.
4. Remove the engine oil pressure sensor fitting, if necessary.
INSTALLATION PROCEDURE
