C 1500 Truck 2WD V6-4.3L VIN W (2001)
15. Connect the power brake booster vacuum hose to the intake manifold.
16. Position the engine wiring harness and engine wiring harness brackets.
17. Install the stud holding the engine wiring harness bracket to the rear of the right cylinder head.
^
Tighten the engine wiring harness bracket stud to 25 Nm (18 ft. lbs.).
18. Install the nut holding the engine wiring harness bracket to the stud at the EVAP canister purge solenoid valve.
^
Tighten the engine wiring harness bracket nut to 9 Nm (80 inch lbs.).
19. Install the nut and the ground wire on the engine wiring harness bracket stud at the rear of the right cylinder head.
^
Tighten the ground wire nut to 16 Nm (12 ft. lbs.).
20. Install the engine wiring harness bracket on the upper intake manifold studs.
21. Install the engine wiring harness bracket nuts.
^
Tighten the engine wiring harness bracket nuts to 12 Nm (106 inch lbs.).