C 1500 Truck 2WD V6-4.3L VIN W (2001)
11.
Route the heater hose behind the generator so that the front of the conduit (3) fits flush against the push on retaining clip (1) and the opening of the
conduit (3) faces the front of the vehicle away from the inlet heater hose clamp (2).
12.
Install the generator cable to the generator and perform the following steps:
Install the generator cable to the stud.
Tighten
Tighten the generator cable nut to 9 N.m (80 lb in).
Position the boot to cover the stud.
13.
Install a retaining bracket (1), P/N 15045464, to the rear of the generator with a bolt (2), P/N 11515764, as shown above.
Tighten
Tighten the bolt to 50 N.m (37 lb ft).
14.
Install a retaining clip (3), P/N 15613086, to the retaining bracket and secure the hoses as shown.
15.
Connect the negative battery cable. Refer to the Battery Negative Cable Disconnect/Connect procedure in the Engine Electrical subsection of the
Service Manual (SI2000 Document ID # 527201).