C 1500 Truck 2WD V8-5.3L VIN T (1999)
Wheel Fastener: Service and Repair
Front
REMOVAL PROCEDURE
^
Tools Required
-
J 43631 Ball Joint Separator
1. Raise and support the vehicle.
2. Remove the tire and wheel assembly.
3. Remove the caliper.
4. Remove the rotor.
5. Remove the wheel stud from the front hub flange using J 43631.
INSTALLATION PROCEDURE
1. Install the new stud into the front hub flange hole using firm hand pressure.
2. Install 4 washers to the new wheel stud
3. Thread a lug nut onto the new stud with the flat side facing the front hub flange.
4. Tighten the lug nut until the stud contacts the back of the front hub flange.
5. Remove the lug nut.
6. Remove the washers
7. Install the rotor.
8. Install the caliper.
9. Install the tire and wheel assembly.
10. Remove the safety stands.
11. Lower the vehicle.
