C 1500 Truck 2WD V8-5.3L VIN T (1999)
Finger tighten the adjuster plug lock nut (5) while holding the adjuster plug (4) stationary.
Pitman Shaft Seals and Bearing Replacement (700 Gear)
DISASSEMBLY PROCEDURE
-
Tools Required
-
J 6278 Pitman Shaft Bearing Remover and Installer
-
J 4245 Internal Snap Ring Pliers
1. Remove the nut (5).
2. Remove the lock washer (4).
3. Remove the pitman arm (3) from the steering gear.
4. Remove the pitman shaft boot (2).
5. Remove the pitman shaft and side cover. Refer to Steering Gear Pitman Shaft and Housing Cover Replacement - Off Vehicle (700 Gear).
6. Clean the exposed end of the pitman shaft.
7. Clean the steering gear housing.
8. Use a wire brush to clean the pitman shaft splines.
9. Remove the dust seal (1).
10. Remove the retaining ring using J 4245.
