C 1500 Truck 2WD V8-6.0L VIN U (2002)
2. Perform the following procedure before installing the backing plate bolts (15 Series only).
2.1.
Remove all traces of the original adhesive patch .
2.2.
Clean the threads of the bolt with brake parts cleaner or the equivalent and allow to dry.
2.3.
Apply Threadlock GM P/N 12345493 or Canadian P/N 10953488 to the threads of the bolt.
Notice: Refer to Fastener Notice in Service Precautions.
3. Install the backing plate bolts.
Tighten the backing plate bolts to 135 Nm (100 ft. lbs.).
4. Install the park brake shoe.
5. Install the axle shaft.
6. Adjust the park brake shoe.
7. Install the rotor.
8. Install the park brake cable to the backing plate mounting bracket until the locking tabs snap into place.
9. Install the rear park brake cable to the park brake actuator lever.
Notice: Refer to Fastener Notice in Service Precautions.
10. Tighten the nut to the intermediate cable at the equalizer.
Tighten the nut to 3.5 Nm (31 inch lbs.).
11. Install the tire and wheel assembly.
12. Remove the safety stands.
13. Lower vehicle.
14. Adjust park brake cable.
Rear (W/NYS)
Disc Brake Backing Plate Replacement Rear (W/NYS)
Caution: Refer to Brake Dust Caution in Service Precautions.
Removal Procedure
1. Release the park brake.
2. Raise and support the vehicle. Refer to Vehicle Lifting.
