C 1500 Truck 2WD V8-6.0L VIN U (2002)
19. Install the rack piston plug (1).
^
Tighten the rack piston plug to 150 Nm (111 ft. lbs.).
20. Install the housing end plug.
Important: Do not adjust the pitman shaft until all components are installed onto the steering gear housing.
21. Install the Pitman shaft seals and bearing.
22. To adjust the steering gear; refer to one of the following procedures:
^
Worm Thrust Bearing Preload Adjustment - Off Vehicle (700 Gear)
^
Pitman shaft Over-Center Preload Adjustment -Off Vehicle (700 Gear)
Steering Gear Motor Assembly Replacement
Steering Gear Motor Assembly Replacement
Removal Procedure
Notice: Refer to Rear Wheel Steering Notice in Service Precautions.
1. Raise the vehicle. Refer to Vehicle Lifting.
2. Remove the spare tire from the vehicle.
3. Remove the bolts (1) retaining the steering gear motor (2) to the steering gear.
4. Remove the steering gear motor from the steering gear.
5. Cover the steering gear motor opening to keep contamination out of the oil in the planetary gear assembly.
