C 1500 Truck 2WD V8-6.0L VIN U (2002)
1. Raise the vehicle. Refer to Vehicle Lifting.
2. Remove the bolts (3) retaining the steering gear protection shield to the steering gear.
3. Remove the steering gear protection shield from the vehicle.
Installation Procedure
1. Install the steering gear protection shield to the steering gear.
Notice: Refer to Fastener Notice in Service Precautions.
2. Install the steering gear protection shield retaining bolts (3) to the steering gear.
^
Tighten the bolts to 180 Nm (132 ft. lbs.).
3. Lower the vehicle.
4. Perform a four wheel alignment.
Steering Gear Check Valve Replacement - Off Vehicle
Steering Gear Check Valve Replacement - Off Vehicle
Disassembly Procedure
Important: Do not to damage the threads of the steering gear housing when removing the check valve.
Remove the check valve (1) from the steering gear housing (2) using a small screwdriver.
Assembly Procedure
