C 1500 Truck 2WD V8-6.0L VIN U (2002)
1. If disassembled, reassemble the valve assembly in the following manner:
1.1.
Alternately install the valve body teflon rings (5) and the O-ring seals (4).
1.2.
Install the valve spool O-ring seal (2) to the valve spool (1).
1.3.
Lubricate the valve spool (1) and O-ring seal (2) with power steering fluid.
2. Simultaneously push and rotate the valve spool (2) into the valve body (1) until the hole (3) in the valve spool (2) for the stub shaft pin is
accessible from the opposite end of the valve body (1).
3. If necessary, install the stub shaft to the valve spool in the following manner:
Lubricate the stub shaft assembly (3).
3.1.
Insert the stub shaft (3} into the valve spool.
3.2.
Insert the pin.
Important: Make sure that the shaft cap notch (1) is mated with the valve body pin before installing the valve body into the steering gear
assembly.
3.3.
The notch in the cap (1) must fully engage the valve body pin (2). Seat the cap against the valve body shoulder.
