C 1500 Truck 2WD V8-6.0L VIN U (2002)
2. Install the upper shock absorber nut and bolt.
3. Install the lower shock absorber nut and bolt.
Tighten the nuts to 95 Nm (70 ft. lbs.).
4. Connect the electrical connector and air line if equipped with RTD.
5. Connect the RTD sensor, if equipped.
6. Remove the support from the rear axle.
7. Remove the safety stands.
8. Lower the vehicle.
Shock Absorber Disposal
Shock Absorber Disposal
Caution: Gas charged shock absorbers contain high pressure gas. Do not remove the snap ring from inside the top of the tube. If the snap
ring is removed, the contents of the shock absorber will come out with extreme force which may result in personal injury.
Caution: To prevent personal injury, wear safety glasses when centerpunching and drilling the shock absorber. Use care not to puncture the
shock absorber tube with the centerpunch.
