C 1500 Truck 2WD V8-6.5L DSL Turbo VIN F (1998)
4. Align the retainers with the holes in the door.
5. Install the trim panel to the door by carefully applying pressure in order to seat the retainers.
6. Install the window regulator handle, as necessary.
7. Install the power accessory switch mounting panel, as necessary.
8. Install the trim panel armrest screw.
Tighten
Tighten the trim panel armrest screw to 2 N.m (18 lb in).
9. Insert the screw cover.
10. Install the trim panel upper extension.
11. Install the door handle bezel.
12. Connect the negative battery cable.
Inside Door Handle
Removal Procedure
Tools Required
J 34940 Rivet Gun
1. Remove the trim panel.
2. Remove the water deflector.
3. Remove the inside door handle assembly by completing the following steps:
^
Drill out the rivet head using a 5-mm (0.2-in) drill bit.
^
Slide forward the door handle.
4. Disconnect the control rods from the handle and the lock lever.
Installation Procedure
1. Connect the control rods to the handle and the lock lever.
2. Install the inside door handle by completing the following steps:
^
Insert the handle assembly into the slot.
^
Slide the assembly to the rear.
^
Using the J 34940, install the handle rivet.
3. Install the water deflector.
4. Install the trim panel.
Inside Handle Bezel
