C 1500 Truck 2WD V8-6.5L DSL Turbo VIN F (1998)
Adjust
-
If replacing heater inlet connector, remove retainer from hose and discard, as new connector is equipped with retainer.
-
If replacing hose. remove retainer from hose and reinsert in connector.
-
If reusing hose and connector, retainer can remain in place on hose.
Install or Connect
1. Push hose into connector until retainer tabs lock.
-
Pull back on hose to check for proper engagement
2. Inlet hose to heater core.
3. Inlet hose clamp.
4. Inlet hose mounting screw.
Tighten
-
Screw to 30 N.m (22 lb ft).
5. Engine coolant.
-
Check the system for leaks.
