C 1500 Truck 2WD V8-6.5L DSL Turbo VIN F (1998)
5. Remove the filter by lifting it straight up and out of the filter assembly. It is not necessary to drain fuel from the filter assembly to change the filter
element since the fuel will remain in the filter assembly's cavity.
INSTALLATION PROCEDURE
IMPORTANT: Make sure the mating surface between the element assembly and the filter assembly is clean before installation.
1. Install the new filter by aligning the widest key slot located under the element assembly cap with the widest key in the header assembly.
2. Push the element, in a downwards direction until the mating surfaces make contact.
3. Install the element nut.
Tighten
-
Tighten the element nut securely by hand.
4. Bleed air from fuel manager/filter. Refer to Bleeding Air from Fuel Supply System. See: Fuel Delivery and Air Induction/Service and Repair
5. Install the upper intake manifold cover.
6. Install fuel tank filler cap.
