C 1500 Truck 2WD V8-6.5L DSL Turbo VIN S (1997)
Front Door Inner Handle Assembly
Tool Required:
J 34940 Rivet Gun
Remove or Disconnect
1. Trim panel.
2. Water deflector.
3. Inside door handle assembly.
^
Drill out the rivet head using a 5-mm (3/16-inch) drill bit.
^
Slide door Handle forward.
4. Control rods from the handle and lock lever.
Install or Connect
1. Control rods to handle and lock lever.
2. Inside door handle.
^
Insert handle assembly into slot and slide assembly to the rear.
^
Handle rivet using J 34940.
3. Water deflector.
4. Trim Panel.
Inside Handle Bezel
Front Door Inside Handle Bezel
Remove or Disconnect
1. Handle bezel from door trim panel.
A. Insert a flat blade tool between the door inside bezel and the handle assembly.
B. Carefully bend retaining clips outward while pulling out the bezel.