C 1500 Truck 2WD V8-6.5L DSL Turbo VIN S (1997)
Voltage Signal: Testing and Inspection
Circuit Description
The Cruise control multi function lever is wired directly to the PCM. The cruise ON/OFF, set/coast and resume/accel signals are inputs to the fuel
control portion of the PCM. These inputs allow the PCM to control and hold a requested speed. The cruise can be disengaged at anytime time by
applying the brakes. This input is sent to the PCM by the Cruise Control Brake Switch. If the cruise is inoperative and no Cruise Control or Brake Switch
DTC(s) are stored, check for the following conditions:
^ A malfunctioning cruise multi function switch/wiring harness (opens or poor connections).
^ A clutch pedal switch stuck in the open position.
Other conditions that will not allow the Cruise Control to engage that are not the fault of the cruise system.
^ Vehicle speed below 25 MPH (if cruise is already set, cruise will disengage at 20 MPH).
