C 1500 Yukon 2WD V8-4.8L VIN V (2000)
8. Remove the wire harness retainers along the windshield pillar.
9. Follow the routing of the wire harness through the IP and release any wire harness retainers.
10. Carefully pull out the wire harness from the windshield pillar ensuring that the wire harness does not get caught on any part.
11. Remove the center trim pillar moldings.
12. Remove the third pillar trim pillar moldings.
13. Remove the rear corner trim pillar moldings.
14. Disconnect the electrical connector to the rear view mirror.
15. Remove the upper console.
16. Remove the front sunshades.
17. Remove the sunshade holders.
18. Remove the rear coat hook, if equipped.
19. Remove the assist handles.
20. Remove auxiliary climate control console assembly.
21. Remove the roof mounted air outlet louver by turning counter clockwise in order to remove the retainer.
22. Remove the retainer.
23. Remove the rear headliner retainers, if needed.
24. Carefully separate the air duct at the right C-pillar from the headliner.
25. Carefully separate the headliner from the roof Velcro(R) retainers.
26. With the aid of an assistant carefully slide the headliner out through the rear of the vehicle.
27. Remove the interior dome lamp assembly in order to transfer to the new headliner.
Installation Procedure
1. Install the interior dome lamp assembly to the new headliner.
2. With the aid of an assistant carefully slide the headliner in through the rear of the vehicle.
3. Secure the headliner to the roof Velcro(R) retainers while aligning the air duct at the right of the third pillar.
4. Install the retainer through the air outlet louver
5. Install the air outlet louver by turning clockwise till it is seated in place.
6. Install the auxiliary climate control assembly..
7. Install the assist handles.
8. Install the interior dome lamp.
9. Install the rear coat hook, if equipped.
10. Install the sunshade holders to the headliner.
11. Install the front sunshades.
12. Connect the electrical connector to the rear view mirror, if needed.
13. Install the upper console.
14. Install the rear corner trim pillar moldings.
15. Install the third pillar trim moldings.
