C 1500 Yukon 2WD V8-4.8L VIN V (2000)
7. Remove the cable from the lever.
8. Remove the cable from the backing plate by depressing the locking tabs.
9. Remove the cable.
Installation Procedure
1. Install the cable taking care to correctly route the cable through the guides and the body mounts.
2. Install the cable to the backing plate by pressing the cable into place until locking tabs snap into place.
3. Install the cable to the lever.
Notice: Refer to Fastener Notice in Service Precautions.
4. Install the cable at the shock absorber bracket and install the bolt.
^
Tighten the bolt to 25 N.m (18 lb ft).
