C 1500 Yukon 2WD V8-4.8L VIN V (2000)
Intake Manifold: Service and Repair
Intake Manifold Replacement
Removal Procedure
Caution: Refer to Battery Disconnect Caution in Service Precautions.
1. Disconnect the battery negative cable. Refer to Battery Negative Cable Disconnect/Connect Procedure.
2. Drain the engine coolant. Refer to Draining and Filling Cooling System in Cooling System.
3. Remove the engine sight shield. Refer to Engine Sight Shield Replacement
Caution: In order to avoid possible injury or vehicle damage, always replace the accelerator control cable with a NEW cable whenever you
remove the engine from the vehicle.In order to avoid cruise control cable damage, position the cable out of the way while you remove or
install the engine. Do not pry or lean against the cruise control cable and do not kink the cable. You must replace a damaged cable.
4. Disconnect the accelerator control cable and the cruise control cable, if equipped, from the throttle shaft. Refer to Accelerator Controls Cable
Replacement in Powertrain Management.
5. Position the cables to the side.
6. Remove the engine sight shield mounting bracket and the bolts.
7. Remove the air cleaner duct.