C 1500 Yukon 2WD V8-4.8L VIN V (2000)
6. Install the engine electrical harness and nut.
Tighten the engine wiring harness nut to 10 Nm(89 inch lbs.).
7. Route the harness over the engine, then install the following connectors.
^
EVAP
^
TP
^
MAP
^
Fuel pipes
^
IAC
^
Eight fuel injector connectors
Caution: In order to avoid possible injury or vehicle damage, always replace the accelerator control cable with a NEW cable whenever
you remove the engine from the vehicle.
In order to avoid cruise control cable damage, position the cable out of the way while you remove or install the engine. Do not pry or lean
against the cruise control cable and do not kink the cable. You must replace a damaged cable.
^
Install the engine sight shield mounting bracket and the bolts.
^
Install the accelerator control cable and the cruise control cable, if equipped, to the throttle shaft. Refer to Accelerator Controls Cable
Replacement in Powertrain Management.
8. Install the engine sight shield. Refer to Engine Sight Shield Replacement.
9. Install the EGR pipe bracket. Refer to Exhaust Gas Recirculation (EGR) Pipe Replacement in Powertrain Management.
