C 1500 Yukon 2WD V8-4.8L VIN V (2000)
Wheel Fastener: Service and Repair
Front
^
Tools Required
-
J 43631 Ball Joint Separator
Removal Procedure
1. Raise and support the vehicle. Refer to Vehicle Lifting.
2. Remove the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation in Wheels, Tires and Alignment.
3. Remove the caliper. Refer to Brake Caliper Replacement- Front.
4. Remove the rotor. Refer to Brake Rotor Replacement- Front.
5. Remove the wheel stud from the front hub flange using J43631.
Installation Procedure
1. Install the new stud into the front hub flange hole using firm hand pressure.
2. Install 4 washers to the new wheel stud.
3. Thread a wheel nut onto the new stud with the flat side facing the front hub flange.
4. Tighten the lug nut until the stud contacts the back of the front hub flange.
5. Remove the wheel nut.
6. Remove the washers.
7. Install the rotor. Refer to Brake Rotor Replacement- Front.
8. Install the caliper. Refer to Brake Caliper Replacement- Front.
9. Install the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation in Wheels, Tires and Alignment.
10. Remove the safety stands.
11. Lower the vehicle.
