C 1500 Yukon 2WD V8-5.3L VIN T (2002)
18. Remove the assist handles.
19. Remove auxiliary climate control console assembly.
20. Remove the roof mounted air outlet louver by turning counter clockwise in order to remove the retainer.
21. Remove the retainer.
22. Remove the sunroof finishing lace, if equipped.
23. Remove the rear headliner retainers, if needed.
24. Carefully separate the air duct at the right C-pillar from the headliner.
25. Carefully separate the headliner from the roof Velcro(R) retainers.
26. With the aid of an assistant carefully slide the headliner out through the rear of the vehicle.
27. Remove the interior dome lamp assembly in order to transfer to the new headliner.
Installation Procedure
1. Install the interior dome lamp assembly to the new headliner.
2. With the aid of an assistant carefully slide the headliner in through the rear of the vehicle.
3. Secure the headliner to the roof Velcro(R) retainers while aligning the air duct at the right of the third pillar.
4. Install the retainer through the air outlet louver
5. Install the air outlet louver by turning clockwise till it is seated in place.
6. Install the auxiliary climate control assembly.
7. Install the assist handles.
8. Install the interior dome lamp.
9. Install the rear coat hook, if equipped.
10. Install the sunshade holders to the headliner.
11. Install the front sunshades.
12. Connect the electrical connector to the rear view mirror, if needed.
13. Install the upper console.
14. Install the rear corner trim pillar moldings.
15. Install the third pillar trim moldings.
16. Install the center trim pillar moldings.
17. Carefully route the wire harness through the IP in order to connect the wire to the junction block located next the brake pedal.
18. Install the transfer case control module, if equipped.
